Parkside PEH 30 A1 - Manual (Page 11)

11 GB
Q
The planing process
CAUTION! DANGER OF KICKBACK!
Always switch on the device before placing it
against the workpiece.
Set the required cutting depth.
Switch on the device.
Always place the front part of the sole 9 down
first on to the workpiece.
Guide the device with even forward movement
over the surface being planed.
Move the device forward at a slow rate and
ensure that the contact pressure acts evenly on
the sole
9 . Moving forward at too great a rate
results in a poorer surface quality and can lead
to blocking of the planing debris removal port.
Q
Chamfering edges (see Fig. H)
The V-grooves 10 in the front sole 9 allow the device
to be used for simple chamfering of workpiece edges.
Use the V-groove most appropriate to your
desired chamfer width.
Place the planer with the V-groove 10 on the work-
piece edge and guide the planer along the edge.
Q
Using the guide fence (see Fig. I)
Attach the guide fence 6 to the device with
the fixing screw 7 .
Release the fixing nut 8 and set the guide at
the desired distance.
Retighten the fixing nut 8 .
Exert some slight sideways pressure when guid-
ing the planer with the guide fence.
Q
Using the rebate depth stop
(see Fig. J)
Attach the rebate depth stop 12 to the device
with the fixing screw 11 .
Set the desired rebate depth with the rebate
depth stop
12 .
Make the required number of passes with the
planer until desired rebate depth is achieved.
Q
Removing and installing a
planer blade
20
(see Fig. D)
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
CAUTION! The sharp cutting edges of the plan-
er blade
20 present an injury hazard! Never
touch the cutting edges of the planer blade 20 .
The planer blade 20 has two cutting edges and it
can be fitted either way around.
Replace the planer blade 20 when both cutting
edges are blunt.
Do not resharpen the planer blades 20 .
Reversing or replacing a planer blade 20
IMPORTANT INFORMATION:
Do not release the two Allen keys. They are used to
adjust the height of the blade shaft.
Adjustment is necessary only if you wish to use a
different planer blade type e.g. a profiled blade.
Always replace both blades at the same time to
avoid out of balance forces.
NOTE: If you only release one blade first then you
can use the factory-fitted second blade for orientation
when you fit the new blade.
1. Release the 3 bolts of the cutting element
18
using the supplied open spanner 26 .
Press the removable side guard 21 into the slot
in the housing.
2. Push the cutting element 18 sideways out from
the blade shaft 17 .
3. Push the planer blade 20 sideways out from
the cutting element 18 .
4. Reassembly is carried out in the reverse order
with a reversed or new planer blade.
5. Planer blades 20 can be obtained from the
service address indicated (see section about
warranty).
General safety advice for electrical power tools / Preparing for use Preparing for use