Parkside PLP 100 A1 - Manual (Page 55)

55 GB
Switching off:
Release the ON / OFF switch 4 .
Pause: At least 48 seconds
CAUTION! Never heat up the device if it is not fitted with a sol-
dering tip.
ATTENTION! Never use in continuous operation mode. The flow
of electrical current controls the delivery of soldering heat. As soon
as the ON / OFF switch
4 is released, the delivery of soldering
heat drops. If the ON / OFF switch 4 is pressed again, the deliv-
ery of soldering heat rises. Pay particular attention to achieving an
even delivery of soldering heat to ensure the highest soldering quali-
ty. You can do this by not allowing the soldering tip
1 to become
excessively hot.
Note: The device has a soldering light
3 to illuminate the work-
ing area.
Q
Replacing a soldering tip
CAUTION! DANGER OF BURNS! Allow the device to
cool down before replacing a soldering tip.
Release the two union nuts 2 using the open spanner 9 .
Pull the soldering tip 1 or 7 out of the holder.
Insert another tip into the holder.
Tighten the two union nuts 2 using the open spanner 9 .
Use Safety advice / Use