Parkside PDFP 500 A1 - Manual (Page 10)

10 GB
regulator 7 as described below under “Increas-
ing the air quantity” up to the maximum setting.
Increasing the air quantity:
Note: Increasing the amount of air is generally
advisable when the degree of atomization is too
coarse.
Turn the air quantity regulator 7 in an anti-
clockwise direction.
Reducing the air quantity:
Note: Reducing the amount of air is generally
advisable when the paint spray is too strong.
Turn the air quantity regulator 7 in a clock-
wise direction.
Maintenance and Cleaning
Note: Thorough cleaning after each use is very
important for safety and operation.
Otherwise, for example, the needle will become
clogged and the proper functioning of the appliance
can no longer be guaranteed.
Wear suitable protective gloves
when carrying out cleaning work.
Do not use any hydrocarbon-containing halo-
gen solvents, such as trichloromethyl, ethyl
chloride, etc., as they undergo chemical reac-
tions with some materials of the paint spray
gun. This can lead to dangerous reactions.
ATTENTION! Never immerse the paint spray
gun completely in solvent.
After each use, spray thinner (only in the open
air – danger of explosion!) or water
through the device.
To clean the casing, nozzle head 9 and the
spray holes inside it, use a cloth or the cleaning
brush provided.. Never use petrol, solvents or
cleaning agents that attack plastic.
First unscrew the stroke stop screw 4 by turning
it anti-clockwise .
Remove the spring 11 .
Remove the needle 10 with the aid of pliers
(see Fig. A).
Clean the needle 10 carefully with the brush 12 ,
also refer to Fig. B.
Replace the needle 10 in the paint spray gun.
Position the spring 11 on the end of the needle 10 .
Tighten the stroke stop screw 4 by turning it
clockwise .
Unscrew the flow cup 3 from the gun by tur-
ning anticlockwise .
Remove the filter 13 , as shown in Figure C, and
clean it with the cleaning brush.
Clean the interior screw thread 14 of the flow
cup 3 with the cleaning brush (see Fig. D).
Replace the filter in the gun (see Fig. C) and tigh-
ten the flow cup
3 by turning it clockwise .
For rust protection you can spray sewing ma-
chine oil through the device after cleaning.
Lubricate all moving parts from time to time.
After cleaning the needle, the thread and seal
must be lightly treated with grease.
Do not use any lubricants containing silicone.
Only store compressed air tools in dry areas.
Service
Compressed air-oper-
ated equipment should only be repaired
by qualified specialists and with original
spare parts. This will ensure that devices
remain safe.
Warranty
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof of
purchase. In the event of a warranty claim,
please make contact by telephone with our
Service Department. Only in this way can a
post-free despatch for your goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
Warranty / Disposal / Declaration of Conformity / Manufacture Initial use / Maintenance and Cleaning / Service / Warranty