Using the accessories (see ill. d), Cleaning and care – Parkside PABK 60 A1 User Manual

Page 11

Using the accessories (see Ill. D)

Air mattress adapter

, ball needle

Use a pipe wrench to unscrew the nozzle

9 a

the air blow gun

Then – depending on what is needed – screw

on the air mattress adapter

or the ball nee-

dle

, as well as the thread adapter

into

the barrel of the air blow gun

Universal valve connection

Screw the universal valve connection

directly

onto the compressed air hose

Cleaning and care

Thoroughly clean the spray stylus

immedi-

ately after use. Otherwise the paint can dry and
cause problems during the next use.

Thoroughly rinse out the spray stylus

with

water.

Use the thinner included to clean any stubborn

dried paint.
Note: The thinner is not suitable for water-so-
luble paints. Rather, it corresponds to a varnish
for thinning paints containing solvents.
Note: If you remove the paint nozzle of the
air blow gun

during cleaning, lubricate the

threads before reattaching it so its freedom of
movement is not affected.

Never lay the entire air blow gun

in a sol-

vent bath.
Note: If the air intake of the compressor should
become dirty, use a dry cloth to remove the ac-
cumulated dirt.

Fault

Interrupted paint jet

or intermittent paint

delivery

Cause

Solution

1. Paint almost

empty

1. Fill paint

2. Paint too viscous 2. Lower viscosity
3. Dry / defective

nozzle

3. Screw in nozzle tightly

or replace

Fault

Interrupted paint jet

or intermittent paint

delivery

Cause

Solution

4. Paint supply

restricted

4. Cleaning

5. Incorrect posi-

tion of spray

stylus

5. Correct position angle

Fault

Spray pattern

incomplete

Cause

Solution

1. Air head

dirty / defective

1. Clean / replace air head
1. Rinse with clear water

2. Nozzle dirty /

defective

2. Clean / replace air

nozzle

Fault

Spray pattern irregu-

lar with drips

Cause

Solution

1. Defective nozzle 1. Replace nozzle. Contact

a respective service centre.

2. Paint too viscous 2. Lower viscosity
3. Insufficient

working pres-

sure

3. Increase working pres-

sure (if necessary, not in-

cluded accessories, e.g.

pressure reducer)

3. Hose defective; replace

hose

Fault

Non-uniform paint

amount delivered

Cause

Solution

Nozzle dirty /

defective

Clean / replace air nozzle

Preparations for use / Cleaning and care

Preparations for use

73868_par_Airbrush_Set_Content_LB4 (CZ-SK).indd 11

06.07.12 12:26