Parkside PABS 18-Li B2 - Manual (Page 48)

48 GB
Select a high setting for large screws, hard
work materials and for the extraction of screws.
For drilling, push the selector to the setting for
drilling, in that you adjust the torque pre-selector
to the position .
For drilling tasks, also push the gear selector
switch
1 to the front (Position: 2).
Q 2 Gear Drive
CAUTION! Move the gear selector switch 1
only after the device has come to a standstill.
Failure to observe this advice may result in damage
to the device.
In the first gear (Gear selector switch 1
in Position: 1)
A speed of up to approx. 400 rpm can be achieved
and a high torque. This setting is intended for use with
all screwing tasks and for accessories (see example
Fig. B).
In the second gear (Gear selector switch
1
in Position: 2)
It achieves a speed of up to approx. 1400 rpm, for
the carrying out of drilling tasks (see example Fig. A).
Q
Preparing the tool for use
Q
Switching ON /OFF
Switching on:
To start the appliance squeeze on the ON /
OFF switch
3 and then keep it pressed down.
The LED working light 12 comes on with a slightly
or fully pressed ON /OFF switch 3 and illumi-
nates the working area in poor lighting conditions.
Switching off:
To stop the appliance, release the ON / OFF
switch
3 .
Switching the LED light on and off
Switching on:
Press the LED light button 8 to switch on the
LED light 9 .
Switching off:
Press the LED light button 8 again to switch
off the LED light 9 .
Q Adjusting the speed
The ON / OFF switch 3 has a variable speed con-
trol device. Slight pressure on the ON / OFF switch
3 will cause the rotation speed to slow down. With
increased pressure, the rotational speed will increase.
Note: The integrated engine brake means that the
device will come to a fast standstill.
Q Switching direction of rotation
To switch the direction of rotation, push the
direction of rotation switch
2 to either the
right or to the left.
Q
Tips and Tricks
Before you use the appliance, check to see
that the screw or drill bit is properly fitted, i.e.
located centrally in the chuck.
Screw bits are designated with their dimensions
and their shape. If you are unsure, always try
the particular screw bit out to see whether it sits
in the screw head without any free play.
Torque:
Smaller screws and bits in particular can be
easily damaged if you adjust the appliance
with too high a torque and/or rotation speed.
Hard screwdriving conditions (into metal):
Particularly high torques can occur, for example
with metal screws tightened by socket tool bits.
Select a lower rotation speed.
Preparing the tool for use / Cleaning and Maintenance / Service / Warranty Before first use / Preparing the tool for use