Parkside PDFP 500 A1 - Manual (Page 10)

10 GB
regulator 7 as described below under “Increas-
ing the air quantity” up to the maximum setting.
Increasing the air quantity:
Note: Increasing the amount of air is generally
advisable when the degree of atomization is too
coarse.
j Turn the air quantity regulator 7 in an anti-
clockwise direction.
Reducing the air quantity:
Note: Reducing the amount of air is generally
advisable when the paint spray is too strong.
j Turn the air quantity regulator 7 in a clock-
wise direction.
Q Maintenance and Cleaning
Note: Thorough cleaning after each use is very
important for safety and operation. Otherwise, for
example, the nozzle will become clogged and the
proper functioning of the device can no longer be
guaranteed.
J Wear suitable protective gloves
when carrying out cleaning work.
J Do not use any hydrocarbon-containing halogen
solvents such as trichloromethyl, ethyl chloride,
etc., as they undergo chemi-cal reactions with
some materials in the paint spray gun. This can
lead to dangerous reactions
CAUTION! Never place the paint spray gun
completely in solvent.
J After every use spray thinner (only in the
open air – danger of explosion!) or
water through the device.
j Use the cleaning brush supplied or a cloth to
clean the housing. Never use petrol, solvents or
cleaning agents which attack plastic.
j First unscrew the nozzle head 9 by turning in
an anticlockwise direction .
j Loosen and remove the nozzle 10 by unscrewing
it with the installation spanner 11 in an anti-
clockwise direction - see also Figure B. Clean
the needle
12 and the nozzle 10 carefully
with the brush 13 - see also figures C and D.
After cleaning, screw the nozzle head 9 back
on by turning it in a clockwise direction, and
tighten it with the spanner
11 fest.
j For rust protection you can spray sewing
machine oil through the device after cleaning.
j Lubricate all moving parts from time to time.
j After the nozzle has been cleaned the thread
and seal have to be lightly treated with grease.
j Do not use any silicone-containing lubricants.
j Store compressed air equipment only in dry
areas.
Q Service
J
Compressed air-oper-
ated equipment should only be repaired
by qualified specialists and with original
spare parts. This will ensure that devices
remain safe.
Q Warranty
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for
private use only and is not intended for commercial
use.
The warranty is void in the case of abusive and im-
proper handling, use of force and internal tampering
not carried out by our authorized service branch.
Your statutory rights are not restricted in any way
by this warranty.
Initial use / Maintenance and Cleaning / Service / Warranty
64576_par_Druckluft-Farbspritzpistole_content_LB4.indd 10 31.03.11 15:48