Parkside PKO 400 A1 - Manual (Page 9)

moving parts are working correctly, that they
do not jam, and that no parts are damaged.
Make sure that all parts are fitted correctly to
ensure that the equipment remains safe to
use. Unless otherwise stated in the
operating instructions, damaged guards and
parts have to be repaired or replaced by a
customer service workshop. Damaged
switches have to be replaced by a customer
service workshop. Never use an electric
power tool with a switch that cannot be
turned on and off.
■ Important!
For your own safety you must only use the
accessories and additional units listed in the
operating instructions or recommended or
specified by the manufacturer. The use of
mounted tools or accessories other than
those recommended in the operating
instructions or catalog may place your
personal safety at risk.
■ Leave all repairs to a qualified
electrician
Repairs must be left strictly to qualified
electricians or the user might suffer an
accident.
■ Noise
Wear ear muffs when you use the
compressor.
■ Replacing the power cable
To prevent hazards, leave the replacement
of damaged power cables strictly to the
manufacturer or a qualified electrician.
There is a risk of electric shock!
■ Inflating tires
Directly after inflating tires, check the
pressure with a suitable pressure gauge, for
example at your filling station.
■ Roadworthy compressors for building
site operations
Make sure that all lines and fittings are
suitable for the maximum permissible
operating pressure of the compressor.
■ Place of installation
Set up the compressor on an even surface.
■ Make sure that all compressed air lines and
fittings are suitable for the maximum
permissible operating pressure of the
compressor.
■ For pressures above 7 bar it is
recommended to use an air line with a
safety cable.
2.2 Safety instructions for working with
compressed air and blasting guns
■ The compressor pump and lines can
become very hot during operation. Touching
these parts will burn you.
■ The air which is sucked in by the
compressor must be kept free of impurities
that could cause fires or explosions in the
compressor pump.
■ When releasing the hose coupling, hold the
hose coupling piece with your hand. This
way, you can protect yourself against injury
from the rebounding hose.
■ Wear safety goggles when working with the
blow-out pistol. Foreign bodies or blown off
parts can easily cause injuries.
■ Do not blow at people with the blow-out
pistol and do not clean clothes while being
worn. Risk of injury!
2.3. Safety information for paint spraying
■ Do not process any paints or solvents with a
flash point below 75° C. There is a risk of
explosion!
■ Do not heat up paints or solvents. There is a
risk of explosion!
■ If hazardous liquids are processed, wear
protective filter units (face guards). Also,
adhere to the safety information provided by
the manufacturers of such liquids.
■ The details and designations of the
Ordinance on Hazardous Substances,
which are displayed on the outer packaging
of the processed material, must be
observed. Additional protective measures
are to be undertaken if necessary,
particularly the wearing of suitable clothing
and masks.
■ Do not smoke during the spraying process
and/or in the work area. There is a risk of
explosion! Paint vapors are easily
combustible.
■ Never set up or operate the equipment in
the vicinity of a fire place, open lights or
sparking machines.
■ Do not store or eat food and drink in the
work area. Paint vapors are harmful to your
GB/
IE
9
Anleitung_LB6_4010414:_ 25.02.2011 8:48 Uhr Seite 9