Parkside PLBS 30 A1 - Manual (Page 10)

11 GB
Safety advice
drugs, alcohol or medication. One moment of carelessness
when using the device can lead to serious injury.
J DANGER OF BURNS! Never touch the hot soldering
tip or the molten solder. You could suffer burn injuries.
Always let the device cool before you replace components
on the device, clean it or check its condition.
J After use let the soldering pencil cool down in air only. Under no
circumstances quench the tip in water!
J CAUTION! DANGER OF FIRE! Place the soldering
pencil down only in the special multifunctional holder
or on a fire-resistant pad.
J Place the soldering pencil in the multifunctional holder during
pauses in your work.
J Keep the device away from combustible material.
J Never leave the device switched on and unattended.
CAUTION! DANGER OF INJURY! Keep your hands away
from the hot workpiece. The heat from soldering can be conducted
through the workpiece. For this reason you should use the third
hand to hold small workpieces.
J Avoid placing the hot soldering tip in contact with the plastic parts
of the multifunctional holder. Failure to observe this advice may
result in damage to the device.
J If a dangerous situation arises, pull the mains plug immediately
out of the mains socket.
CAUTION! DANGER OF POISONING! Do not breathe air
contaminated with soldering fumes.
J When working with the device for long periods do not
allow the fumes from soldering to build up. They may
be hazardous to health. Always provide adequate
ventilation of your working area. In addition, it is recommended
that you wear protective gloves, a face mask and a protective
apron.
61647_par_Feinloetkolben-Set_PLBS30A1_content_LB4.indd 11 15.02.11 16:42