Parkside PNTS 1400 A1 - Manual (Page 9)

9
GB
Vacuuming.fine.dust:
While vacuuming fine dust, you
may find dirt accumulating faster
than usual. For this reason, we
recommend the use of a paper fil-
ter bag for fine dust.
1. Fit the pleated filter (20).
2. Completely unfold the paper filter bag
(21) and pull it over the internal suction
nozzle (5) in the stainless steel con-
tainer (6) (see ). The connector on
the suction nozzle must be completely
enclosed by the sealing ring on the fil-
ter bag opening.
Wet vacuuming
For wet vacuuming or to vacuum water, fit
the foam filter (18) to the filter basket on
the motor head (1).
When the container is full, the suc-
tion opening is shut off by a float,
and suction is then cut off.
Switch the appliance off, remove
the plug from the socket and
empty the container (see Cleaning/
Maintenance/Storage).
If foam or liquid exits, switch off the
machine immediately.
Blow Function
• To blow, take off the air diffuser (17)
(bayonet fixing).
• Screw the suction hose (15) (bayonet
fixing) onto the blow connection (11)
on the motor head (1).
Cleaning/Maintenance/
Storage
Pull out the mains plug.
Danger of electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.
Cleaning.the.Equipment:
Never.hose.the.appliance.down.
with.water..Never.use.aggres-
sive.cleaning.agents.or.sol-
vents..This.could.damage.the.
appliance..
• After use, empty the stainless steel
container ( No. 6). Opening the
drain plug to allow the vacuumed liquid
to drain out ( No. 7).
A liquid residue remains in the con-
tainer.
• Clean the waste tank with a damp cloth.
• Wash the foam filter ( No. 18) with
lukewarm water and soap, and allow
to dry.
• Beat the dust out of the fluted filter
( No. 20) and clean it with a paint
brush or hand brush.
• Replace the paper filter bag (
No. 21) when full (see “replacement
parts” for reordering)
• Wash out the air diffuser filter (see
no. 17) with lukewarm water and soap
a leave it to dry.
Storage:
- To store, wind the mains power
cable (12) around the cable
holder (9) on the back of the