Parkside PDEXS 150 A1 - Manual (Page 33)

33 GB/MT
before use
Selecting the Grinding Disc
Metal removal and Surface:
The rate of metal removal and the surface quality
are determined by the grain size of the grinding disc.
lease note that corresponding grinding discs
with different grain sizes should be used for
processing different materials.
Changing sanding sheets
The air sander is fitted with a hook and loop fastening,
which allows for quick and easy replacement of
sanding discs.
Lift the grinding disc at the side and pull it off
from the backing pad
6 in order to remove it.
note: Before securing a new sanding sheet, re-
move all dust and dirt from the sander plate
6 .
Ensure that the openings in the sanding sheet
concur with the boreholes of the sanding plate 6 .
Dust / Swarf removal by Suction
Please note the “Safety instructions” section.
Using the internal vacuum extraction
with dust collection device (see Fig. b):
Push the exhaust air hose 9 fully on to the
connection for dust extraction 2 . Put the open-
ing of the dust bag 10 over the free end of the
exhaust air hose 9 and fasten the dust bag 10
firmly in position.
note: Empty the dust bag 10 in good time and
regularly to ensure optimum dust extraction. To
do this open the zip fastener on the underside
of the dust bag
10 .
Topping up the oil
In order for the air sander to have a long service life,
there must always be enough pneumatic oil in the
device.
You may ensure this in any of the
following ways:
Connect a service unit with an oiler to the
compressor.
Install a line oiler in the compressed air line or
at the compressed air device.
Put approx. 3–5 drops of pneumatic oil by
hand into the plug nipple 3 every 15 minutes
of operation.
Preparing for use
Connecting the compressed
air source
note: The air sander must be operated using
cleaned and condensate-free compressed air only
and its maximum allowable working pressure of
6.3 bar at the device must not be exceeded.
note: The compressed air source must be fitted with
a (filter) pressure reducer so that the air pressure can
be regulated.
Connect the plug nipple 3 by a quick-release
coupler to the compressed air supply.
Switching on and off
note: Always switch on the air sander before
bringing it into contact with the workpiece material.
Switching on the air sander:
Press the operator’s lever 1 fully down
(see Fig. C).
Set the speed using the speed control 5 .
Switching off the air sander:
Release the operator’s lever 1 .
After you finish work, disconnect the device
from the compressed air source.
note: First disconnect the hose from the com-
pressed air source (compressor) and only then
disconnect the compressed air supply hose
from the device. This will ensure that the com-
pressed air supply hose does not wave around
in an uncontrolled manner.
Before use / Preparing for use
64578_par_Druckluft-Exzenterschleifer_content_LB5.indd 33 27.06.11 16:21