beautypg.com

Save these instructions, Important safety instructions, For household use only – Euro-Pro EP600 User Manual

Page 3: Trouble shooting guide, Ordering replacement dust cup filters, For technical support

background image

IMPORTANT SAFETY INSTRUCTIONS

TROUBLE SHOOTING GUIDE

When using your SHARK TURBO STICK VAC basic safety precautions should

always be observed, including the following:

ORDERING REPLACEMENT DUST CUP FILTERS

PROBLEM

POSSIBLE REASON

POSSIBLE SOLUTION

VACUUM WILL

NOT OPERATE

1.

Power cord not firmly plugged into
outlet.

2.

No power in wall outlet.

3. Needs

servicing.

4.

Thermostat has tripped.

1.

Plug unit in firmly.

2.

Check fuse or breaker. Replace
fuse/reset breaker.

3. Call

1-800-798-7398.

4.

Turn the unit off and unplug from
outlet. Allow unit to cool down,
then restart.

VACUUM WILL

NOT PICK-UP OR

SUCTION POWER

IS WEAK

1.

Dust cup is full.

2. Unit

clogged.

3. HEPA-Type

Filter

needs

cleaning

or replacing.

4.

Debris screen needs cleaning.

1.

Empty and clean dust cup.

2.

Turn unit off and unplug from
wall outlet. Remove Dust Cup
Filter and check for object(s) in
air duct and remove.

3.

Clean or replace HEPA-Type
Filter.

4. Clean

debris

screen.

DUST ESCAPING

FROM VACUUM

1.

Dust cup is full.

2.

Dust Cup is not installed correctly.

1.

Empty and clean dust cup.

2.

Review Dust Cup instructions.

VACUUM, HOSE

OR BRUSHES

WILL NOT PICK-UP

1. Hose

clogged.

2.

Dust cup is full.

1.

Remove hose and/or brushes.
Remove obstruction from hose
and /or brush.

2.

Empty and clean dust cup.

To reduce the risk of fire, electric shock, or

injury:

Do not leave the SHARK TURBO STICK

VAC plugged in when unattended. Unplug the

electrical cord when not in use and before

servicing.

Do not allow to be used as a toy. Close

attention is necessary when used by or near

children, pets or plants.

Use only as described in this manual. Use

only manufacturer’s recommended

accessories.

Do not pull cord, use cord as a handle, close

a door on cord, or pull cord around sharp

edges or corners. Keep cord away from

heated surfaces.

Use only extension cords UL-rated or cUL at

15 amperes. extension cords rated for less

amperage may overheat. Care should be

taken to arrange the cord so that the cord

cannot be pulled or tripped over.

Turn off all controls as applicable before

unplugging from electrical outlet.

Do not unplug by pulling on cord. To unplug,

grasp the plug, not the cord.

Do not handle plug or hand vacuum with wet

hands or operate without shoes.

Do not put any objects into openings. Do not

use with any opening blocked. Keep free of

dust, lint, hair and anything else that may

reduce air flow.

Store your appliance indoors in a cool, dry

area.

Keep your work area well lit.

Do not immerse the hand vacuum into water

or other liquids.

Keep end of hose, wands and other openings

away from your face and body.

Use only on dry surfaces.

Using improper voltage may result in damage

to the motor and possible injury to the user.

Correct voltage is listed on rating label.

1.

Read all instructions before using your

SHARK TURBO STICK VAC.

2.

Use the system only for its intended use.

3.

To protect against a risk of electric shock,

do not immerse any part of the system in

water or other liquids.

4.

Never yank cord to disconnect from

outlet; instead, grasp plug and pull to

disconnect.

5.

Do not allow cord to touch hot surfaces.

6.

Do not run appliance over cord.

7.

Do not operate the system with a damaged

cord or plug, or if the appliance or any other

part of the system has been dropped or

damaged. To avoid the risk of electric

shock, do not disassemble or attempt to

repair the SHARK TURBO STICK VAC.

Return the system to EURO-PRO

Operating LLC (see warranty) for

examination and repair. Incorrect re-

assembly or repair can cause a risk of

electrical shock or injury to persons when

the SHARK TURBO STICK VAC is used.

8.

Close supervision is necessary for any

appliance being used by or near children.

Do not leave the system unattended while

connected.

9.

Keep hair, loose clothing, fingers and all

parts of body away from opening and

moving parts.

10. Do not use to pick up flammable or

combustible liquids such as gasoline or use

in areas where they may be present.

11. Do not pick up anything that is burning or

smoking such as cigarettes, matches or hot

ashes.

12. Use extra care when cleaning on stairs.

13. Do not use the hand vacuum without the

HEPA-TYPE dust cup filter in place.

14. This appliance is intended only for

household use. Follow all user instructions

in this manual.

TO ORDER REPLACEMENT HEPA-TYPE FILTERS

Item # XSH600

for Model EP600

Call:

1-866-98SHARK (1-866-987-4275)

Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time

FOR TECHNICAL SUPPORT

for Model EP600

SAVE THESE INSTRUCTIONS

or

visit our website: www.sharkvac.com

Call:

1-800-798-7398

Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time

For Household Use Only

Please Note:

The HEPA-TYPE Filter is washable. It should, however, be replaced every three (3)

months to ensure peak performance of your vacuum.

Both the Pre-Motor and Post Motor Filters are washable. They should however be

replaced every three (3) months to ensure peak performance of your vacuum.

Important:

Make sure that ALL filters have been completely air dried for 24 hours before re-

installing back in the vacuum.

WARNING:

To reduce the risk of electric shock, this appliance has

a polarized plug (one blade is wider than the other). This plug will fit
in a polarized outlet only one way. If the plug does not fit fully in the

outlet, reverse the plug. If it still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the plug in any way.

8

Rev. 04/01

1