Electrolux 80860 i - Manual (Page 14)

Operating Instructions
14
Setting the Audible Signal for the End of the Wash
Programme
The dishwasher can be set to emit an audible signal at the end of a
wash cycle.
0 1. The dishwasher must be switched off.
2. Press the signal tone and water softener buttons simultaneously and
keep them pressed.
3. Press the ON/OFF button. The LED indicators for the signal tone and
water softener buttons flash.
4. Press the signal tone button again.
The multi-display indicates the current setting:
5. Pressing the signal tone button changes the setting.
6. Once the multi-display indicates the required setting, press the ON/OFF
button. The setting is then saved.
In Daily Use
• Check the salt and rinse aid levels.
• Load cutlery and dishes into the dishwasher
• Fill with dishwasher detergent
• Select a wash programme suitable for the cutlery and dishes
• Start the wash programme
b0
Signal tone switched off
b1
Signal tone switched on (factory setting)