Electrohome 4 - Manual (Page 11)

Need help? Call 1-800-950-7044
11
If your device does not turn off after you
press the number keys, press
CHAN ^ , then
press PWR again. If the device turns off,
press SETUP to lock in that code.
If your device still does not turn off, press the
numbers
1 through 9 and 0 , one at a time, to
see if the device responds. If the device
turns off after you press one of the digit keys,
press
SETUP to lock in that code.
If your device still does not turn off after you
press the number keys again, press
CHAN ^ ,
then press PWR again. If the device turns off,
press SETUP to lock in that code.
If your device still does not turn off, press the
numbers
1 through 9 and 0 , one at a time, to
see if the device responds. If the device
turns off after you press one of the digit keys,
press
SETUP to lock in that code.
Note: If your device still does not respond,
follow the steps in “If You Have Problems” on
Page 32.
Repeat Steps 2–5 for additional devices.
DETERMINING THE 4-DIGIT
CODE
After you set up your Phone Up 4, you can find
which 4-digit device code the Phone Up 4 is set to
by following these steps. We recommend that you
do this and write down this information so you can
easily enter it if your remote control ever stops
working.
1. Press the device key you want to get the
manufacturers’ codes from.
2. Press and hold SETUP until the red light
blinks twice, then release it.
15-1917.fm Page 11 Monday, July 19, 1999 12:25 PM