Linx Technologies SDM-USB-QS-S - Manual (Page 4)

– – – – 2 3
QS Series USB Module Specifications
Parameter Symbol Min. Typ. Max. Units Notes
Power Supply
Operating Voltage V
CC
4.35 5.0 5.25 VDC
Supply Current l
CC
26.0 28.0 mA
UART SECTION
Data Rate 0.0003 3.0 Mbps
Data Output:
Logic Low V
OL
0.3 0.4 0.6 VDC
Logic High V
OH
3.2 4.1 4.9 VDC
EEPROM Size 1,024 Bits
USB Section
Data Output:
Logic Low UV
OL
0.0 0.3 VDC
Logic High UV
OH
2.8 3.6 VDC
Single-Ended RX Threshold UV
SE
0.8 2.0 VDC
Differential Common Mode UC
OM
0.8 2.5 VDC
Differential Input Sensitivity UV
DIF
0.2 VDC
Driver Output Impedance UD
RVZ
29 44 Ω
Environmental
Operating Temperature Range 0.0 +70 °C
Electrical Specifications Ordering Information
Ordering Information
Part Number Description
SDM-USB-QS-S QS Series USB Module
MDEV-USB-QS QS Series Master Development Kit
Figure 2: Ordering Information
Absolute Maximum Ratings
Figure 3: Absolute Maximum Ratings
Figure 4: Electrical Specifications
Absolute Maximum Ratings
Supply Voltage V
cc
−0.5 to +6.0 VDC
Any Input or Output Pin −0.5 to V
CC
+ 0.5 VDC
Max. Current Sourced by Output Pins 24 mA
Operating Temperature 0 to +70 ºC
Storage Temperature −65 to +150 ºC
Exceeding any of the limits of this section may lead to permanent damage to the device.
Furthermore, extended operation at these maximum ratings may reduce the life of this
device.
Warning: This product incorporates numerous static-sensitive
components. Always wear an ESD wrist strap and observe proper ESD
handling procedures when working with this device. Failure to observe
this precaution may result in module damage or failure.