English Leather 245R/RX - Manual (Page 21)

English – 21
ASSEMBLY
Assembling the handlebar and
throttle
(265RX)
• Fit the left handlebar in the handlebar mounting.
• Fit the right handle to the handlebar.
• Adjust roughly and tighten the screws slightly.
• Now make a final adjustment, with the machine hanging
from the harness, to obtain the most comfortable working
position. Tighten the screws.
• Make the final adjustment to the right handle and lock it in
the most comfortable position.
Adjusting the throttle trigger
The throttle trigger can be adjusted to give the best working
position. This is done using the Allen screws by the right
handle.
Fitting blades and trimmer heads
When fitting the cutting attachment it is extremely important
that the raised section on the drive disc/support flange
engages correctly in the centre hole of the cutting attachment.
If the cutting attachment is fitted incorrectly it can result in
serious and/or fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.