Linx Technologies RXM-GPS-SR User Manual
Page 8
Page 15
Page 14
100 – SetSerialPort
This command message is used to set the protocol (SiRF binary or NMEA)
and/or the communication parameters (baud rate). Generally, this command is
used to switch the module back to SiRF binary protocol mode where a more
extensive command message set is available. When a valid message is
received, the parameters are stored in battery-backed SRAM and the receiver
restarts using the saved parameters.
The table below contains the values for the following example:
Switch to SiRF binary protocol at 9600,8,N,1
$PSRF100,0,9600,8,1,0*0C
1. SiRF protocol is only valid for 8 data bits, 1 stop bit, and no parity.
2. Default settings are NMEA protocol using 9,600 baud, 8 data bits, 1 stop bit, and no parity.
For details on the SiRF binary protocol, please refer to SiRF’s Binary Protocol
Reference Manual.
Name
Example
Description
Message ID $PSRF100
PSRF100 protocol header
Protocol
0
0=SiRF binary, 1=NMEA
Baud
9600
4800, 9600, 19200, 38400, 57600
DataBits
8
8
1
StopBits
1
1
1
Parity
0
0=None
1
Checksum
*0C
End of message termination
Table 12: SetSerialPort Example
2
101 – NavigationInitialization
This command was used to initialize the receiver with the current position (in X,
Y, Z coordinates), clock offset, and time, enabling a faster fix. Increased receiver
sensitivity and the removal of Selective Availability (SA) have made this
unneccessary. The command is retained for its ability to reset the module, but
the initialization fields are no longer supported.
The table below contains the values for the following example:
$PSRF101,0,0,0,96000,0,0,12,4*1F
Name
Example
Units
Description
Message ID
$PSRF101
PSRF101 protocol header
ECEF X
0
ECEF Y
0
ECEF Z
0
ClkOffset
96000
TimeOfWeek
0
WeekNo
0
ChannelCount
12
ResetCfg
4
See Table 15
Checksum
*1F
End of message termination
Hex
Description
0x01
Hot Start – All data valid
0x02
Warm Start – Ephemeris cleared
0x04
Cold Start – Clears all data in memory
0x08
Clear Memory – Clears all data in memory and resets the receiver back
to factory defaults
Table 13: NavigationInitialization Example
Table 14: ResetCfg Values