Quick reference sheet – Linkskey LDV-002EASK User Manual

Page 2

Quick Reference Sheet

Applicable Models: LDV-002EASK / LDV-004EASK

Quick Reference Sheet

Notes:

When the binding of PC & Audio&Mic switching is enabled by the hotkey sequence: ScrLk + ScrLk + Q, any PC and audio&mic switching are bound together. To remove this binding, use the

hotkey sequence: ScrLk + ScrLk + W.
Important Note: Digital display resolution is up to 1600 x 1200 pixels
Hotkey convention: The hotkey notation ScrLk + ScrLk + (key), denotes that you should hit the individual key consecutively one at a time, not simultaneously.

QUICK REFERENCE SHEET for DVI PS/2 KVM Switch w/ Audio&Mic

Operation Hotkey Commands / Front-Panel Button

Command

Hotkeys

Front-panel Button

Description

Select PC Channel

(Joint-select PC port/hub port
control/audio&mic,

if binding is enabled)

ScrLk + ScrLk + (x)

(x is a top-row number key)
x = 1~2 / x = 1~4 for PC channel no

Press the corresponding button to select
the active PC channel

Select the active PC channel
(Joint-select PC port /audio&mic , if binding is
enabled)

Select Audio&Mic Channel

(Joint-select PC port & audio/mic , if
binding is enabled)

ScrLk + ScrLk + (Fy)

Fy = F5~F6/Fx=F5~F8 (Fy is a function key)
y = 1~2 / y = 1~4 for audio/mic channel no

Select the active Audio&Mic channel
(Joint-select PC & audio&mic channel, if binding is
enabled)

Bind PC & Audio/Mic Switching

[Default]

ScrLk + ScrLk + Q

Enable the binding of PC port and audio&mic
switching. (Once this feature is enabled, any pc
and/or audio&mic switching is bound together)

[Factory Default]

Unbind PC & Audio/Mic
Switching

ScrLk + ScrLk + W

Disable the binding of PC port and audio&mic
switching

Next lower channel

ScrLk + ScrLk +  (arrow up)

Select the next lower connected channel

Next higher channel

ScrLk + ScrLk +  (arrow down)

Press the push button to switch to the
next channel

Select the next higher connected channel

Previous PC channel

ScrLk + ScrLk +  (Backspace)

Toggle between the previous channel and current
channel

Autoscan Beep Sound
On/Off

ScrLk + ScrLk + B

Toggle on/off the beep sound for switching
confirmation while autoscanning

Reset Console Mouse

ScrLk + ScrLk + End

Reset mouse on the console side

Autoscan

ScrLk + ScrLk + S

Autoscan through every connected channel for quick
screen browsing of each channel (default delay time
= 5 sec )

Autoscan
with Programmable
Delay Time

ScrLk + ScrLk + S + (x)

x = 0~9
1  10” ; 2  20” ; 3  30” ; 4  40” ; 5  50”
6  60” ; 7  70” ; 8  80” ; 9  90” ; 0  100”

Autoscan with a user-defined delay time within a
range of 5 ~ 100 seconds

Stop Autoscan

Any key on keyboard

Terminate Autoscan activity

Technical Support
E-mail: [email protected]
Website: www.linkskey.com

This manual is related to the following products:

LDV-004EASK