Linkskey LDV-002ESK - Manual (Page 2)

Q uick R eference S heet Applicable M odels: LD V -002ES K /LD V -004E S K
Q uick R eference S heet
QUICK REFERENCE SHEET for DVI KVM Switch Operation Commands
Hotkeys/ Front-Panel Button
Command Hotkeys Front-panel Button Description
ScrLk + ScrLk + (x)
1
Select P C (x is a top-row number key)
x = 1 ~ 2 or x = 1 ~ 4 for PC channel no.
-- Select the active channel
N ext low er channel ScrLk + ScrLk +  (arrow up) -- Select the next lower connected channel
N ext higher channel ScrLk + ScrLk +  (arrow down)
Press the push button to switch to the
next channel
Select the next higher connected channel
Previous P C channel ScrLk + ScrLk +  (Backspace) --
Toggle between the previous channel and current
channel
A utoscan B eep S ound
O n/O ff
ScrLk + ScrLk + B --
Toggle on/off the beep sound for switching
confirmation while autoscanning
R eset C onsole M o use ScrLk + ScrLk + End -- Reset mouse on the console side
A utoscan ScrLk + ScrLk + S --
Autoscan through every connected channel for
quick screen browsing of each channel (default
delay time = 5 sec )
A utoscan
w ith Program m able
D elay Tim e ScrLk + ScrLk + S + (x)
1
x = 0~9
1  10” ; 2  20” ; 3  30” ; 4  40” ; 5  50”
6  60” ; 7  70” ; 8  80” ; 9  90” ; 0  100”
--
Autoscan with a user-defined delay time within a
range of 5 ~ 100 seconds
Stop A utoscan Any key on keyboard -- Terminate Autoscan activity
Notes:
1 Note that (x) denotes a number key for the selected port number (from 1 ~ 4). You can use either the number keys on the upper row of the keyboard or those on the number pad.
Important Note: Digital display resolution is up to 1600 x 1200 pixels
Hotkey convention: The hotkey notation ScrLk + ScrLk + (key), denotes that you should hit the individual key consecutively one at a time, not simultaneously.
Rev. 1.31 Copyright© All rights reserved. Aug 2004
Technical Support
E-mail:
[email protected]
Website: www.linkskey.com