First-time setup of your television, Information – Bang & Olufsen BeoVision 10 Getting Started User Manual

Page 26

First-time setup of your television

Connections Select the type of equipment connected to each socket, the sockets used,

the product name, and the source name.

Information

This first-time setup procedure is activated when the TV is connected to the mains

and switched on for the first time. If you want to change your setup at a later date,
you can access the same menus and update your settings.

Switch on the TV

Select settings

You are led through the following settings only

when you switch on the TV for the first time.*

However, the sequence of menus depend on the
connections and settings you make.

Wait for the TV to start up.

Switch on

Select setting

Accept and go to next menu item

Set on-screen menu language
Calibrate stand, see page 23
Set stand positions, see page 23
Disable or enable internal TV tuner or DVB
Make standby settings for the TV, see the Guide for further information
Register connected equipment, see the Guide for further information

Tune in TV channels automatically. Available only if TV tuner is enabled. See

Guide for further information.
Make sound adjustments, see the Guide for further information

*NOTE! When you have selected the preferred

settings in a menu, you may have to press the
green button to continue to the next menu in the

first-time setup procedure. Follow the on-screen

instructions.

MENU LANGUAGE
STAND ADJUSTMENT
STAND POSITIONS

TUNER SETUP

STANDBY SETTINGS
CONNECTIONS

AUTO TUNING

ADJUSTMENT

This Getting Started describes operation with Beo4 in MODE1 and the BEO4 SETTING menu set to

NAVIGATION BUTTON, see also page 8.

Please remember to set your Beo4 with navigation button to the MODE corresponding to the setting
you make in the BEO4 SETTING menu, see the Beo4 Guide for further information.