Toshiba DynaPad WT12PE-A64 - Manual (Page 6)

General Safety Instructions
Please read the following safety and operating instructions before using your
Product. Keep the information near your Product for future reference. Also,
please be sure to read your electronic User’s Guide as it contains additional
important Safety Information.
Indicates a potentially hazardous situation which, if not
avoided, could result in serious injury.
AC Adaptor
Always use the Toshiba AC adaptor that was provided with your device or as
specified by Toshiba and use correct power source specified on the regulatory
label of device or adaptor. Always ensure a secure electrical connection. Be
careful if you use a multiple connector to avoid current overload on one socket.
Battery Pack
Do not expose the battery pack to heat or shock.
Disassembly, Modification or Tampering
Do not disassemble, modify, tamper with or repair your device (including AC
adaptor or power cable/cord).
Choking Hazards
Keep device away from small children. This device is not a toy and may be
hazardous to small children, for example, small detachable parts may be a
choking hazard.
Cleaning
Unplug device from the electrical outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. The injected combustible gas produced by these
types of cleaners may remain inside of your product. The electrostatic spark
from the motor or contact point of switch may ignite the gas residue, which
could result in an explosion, fire, or burn injury. Instead use a lightly dampened
cloth for cleaning in general and remove dust with a dry cloth.
Hot Surfaces
Allow the equipment’s internal components and hot-pluggable drives to cool
before touching them
Power Cables/Cords and Power Source
Always use power cables/cords and power sources that comply with the
voltage and frequency specifications and requirements of the country of use.
Service Provider
Disconnect device from the electrical outlet and take device to an authorized
Toshiba service provider if:
• AC adaptor or Micro USB power cable is damaged.
• Liquid has spilled into device or an object (such as a screw, staple or paper
clip) has entered device.
• Device has been dropped, subject to shock or impact and/or damaged in
some way.
• Noticeable signs of overheating, smoke, deformation, cracks, leaks or
unusual odor occur.
• Service is needed on component inside compartments requiring opening or
removal of covers.
Need Help?
Consult the electronic User’s Guide
(Internet connection required)