Lanzar VIBE286 - Manual (Page 8)

V i b e r a n t O w n e r ’ s M a n u a l 1 2 -
Syst e m Wi r i n g
V i b e r a n t O w n e r ’ s M a n u a l - 1 3
Precautions
VIBE 416/426/436 4 CHANNEL TRI-MODE CONFIGURATION
FRONT
REAR
To Remote Output
From Head Unit
To Battery SPEAKER
IMPEDANCE
4-8 OHMS
Y ADAPTOR Y ADAPTOR
TO OUTPUT FROM HEAD UNIT
CH1/2
L
R
R
L
CH3/4
• Before you drill or cut any holes, investigate your car's layout very carefully. Take care when your work near the gas tank, fuel lines, hydraulic
lines and electrical wiring.
• Do not operate the amplifier when it is unmounted. Attach all audio system components securely within the automobile to prevent damage,
especially in an accident.
• Do not mount this amplifier so that the wire connection, or likely to be damaged by nearby objects. Be sure to select a location inside your
vehicle which has adequate ventilation.
• Before making or breaking power connections in your system, disconnect the vehicle battery. Confirm that your head unit or other equipment
is turned off while connecting the input jacks and speaker terminals.
• If you need to replace the power fuse, only replace it with a fuse indentical to that supplied with the system. Using a fuse of a different
type or rating may result in damage to your system which isn't covered by the manufacturer's warranty.
A m pl i f i e r Wi l l N ot P owe r U p.
• Check for good ground connection.
• Check that remote DC terminal has at least 12V DC.
• Check that there is battery power on the "+" terminal.
• Check all fuses.
• Check that Protection LED is not lit. If it is lit, shut off amplifier briefly and then repower it.