Lanner LEC-7050 - Manual (Page 18)

17
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Chapter 4:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unpower the LEC-7050 and remove the power cord. 1.
Unscrew the 4 rubber feet from the bottom cover of 2.
the LEC-7050 System.
Open the cover. 3.
Installing the System Memory
The motherboard supports DDR3 memory to meet the
higher bandwidth requirement of the latest operating
system and Internet applications. It comes with two
double data rate type three (DDR3) Small Outline Dual
Inline Memory Modules (SO-DIMM) sockets.
Cutout
Notch
Note:
The motherboards can support up to 4 GB 1.
memory capacity in maximum.
Installing the Hard Disk
The system can accommodate one Serial-ATA disks. Follow
these steps to install a hard disk into the LEC-7050:
Unscrew the 4 rubber feet from the bottom cover of 1.
the LEC-7050 System.
Place hard disk on the top cover of the system and
2.
align the holes of the hard disk with the mounting
holes of the top cover.
Secure the hard disk with 4 mounting screws from the
3.
outside of cover.
Connect the Serial-ATA power and data cables to the
4.
hard disk’s connectors.
Plug the Serial-ATA cables (power and data) to the
5.
Serial-ATA Connectors on the main board.
1
2