Lanner LEC-2010 - Manual (Page 16)

LEC-2010 Fanless Embedded System User’s Manual
16
2.2.2 Jumper Settings and I/O Connectors
The jumper settings and I/O connectors of the LEC-2010 have been arranged at the factory.
Any changes to the schematic or design of these connectors may cause damage to your unit.
Jumper Settings and I/O Connector Summary for LEC-2010 is as below:
CHAPTER JUMPER FUNCTION
2.2.3.1 SC2T2 Select COM2 Type Jumper
2.2.3.2 SC2T1 Select COM2 Type Jumper
2.2.3.3 PCOM1 Select COM1 Pin9 Signal Jumper
2.2.3.4 KM1
Keyboard/Mouse Connector Header
2.2.3.5 USBG1 USB Port#7 5-Pin Power Connector (5P Male)
2.2.3.6 SODIMM1
200 PIN DDR2 SODIMM Socket
2.2.3.7 SC3T2 Select COM3 Type Jumper
2.2.3.8 SC3T1 Select COM3 Type Jumper
2.2.3.9 VLCD1 Select Panel Voltage Header (Reserved)
2.2.3.10 INVER1 7 Pin LCD INVETER Connector (Optional)
2.2.3.11 LVDS1
LVDS Connector (Optional)
2.2.3.12 PS4S1 4-Pin Power Connector (4P Male )
2.2.3.13 SATA2 Serial ATA-SATA Socket (Port 2)
2.2.3.13 SATA1 Serial ATA-SATA Socket (Port 1)
2.2.3.14 LNI1 Line In 3Pin Connector
2.2.3.15 CF1 Compact Flash Connector
2.2.3.16 CCMOS1 Clear CMOS Data Jumper
2.2.3.17 CARPSC1 Car Application 5-Pin Power Connector (5P Male)
2.2.3.18 MPCIE1 Mini PCI Express 1X Connector
2.2.3.19 PCIGF1
120 Pin PCI Golden Finger
2.2.3.20 PCIEGF1 PCI Express 1x Golden Finger
2.2.3.21 COM1/2 Serial Port COM1/2 Connector (D-SUB9 Male)
2.2.3.22 CN1
COM3 – 6 Connector
2.2.3.23 CN2 DC-IN Connector (9 ~ 36V)
2.2.3.24 DGIO1 DIO Connector ( D-SUB9 Female)
2.2.3.25 PSW1 SW Connector (ATX Power Switch Connector)
2.2.3.26 PSBTN1 PW-ON Button
2.2.3.27 MIC1
MIC IN Connector
2.2.3.28 LNO1 LINE OUT Connector