Laney LX120RH - Manual (Page 7)

SPECIFICATIONS
This product conforms to the requirements of the following European Regulations, Directives & Rules:
CE Mark (93/68/EEC), Low Voltage (72/23/EEC), EMC (2004/108/EEC),
RoHS (2011/65/EU), WEEE (EU2002/96/EC)
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal
household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the
WEEE (Waste Electrical and Electronic Equipment) directive applicable in your country.
BLOCK DIAGRAM
Supply Voltage ~100V, ~120V, ~220V, ~230V, ~240V 50/60Hz Factory Option
Mains Fuse ~220V>~240V = T1A L. ~100>~120V = T2A L
Power Consumption 220W
Output Power Rating 120W
Features TEC Tube Emulating Technology
XTS eXtreme Tone Shaping (Drive channel only)
Twin speaker socket (Minimum 4 Ohm Impedance)
AUX IN (10K Input impedance) (Nominal 750mV Input level)
FX Loop (Nominal 750mV Level)
Footswitchable Yes, Channel and FX (FS2 Not Included)
Reverb Yes
EQ Both channels contain separate Passive Bass, Middle and Treble
Input Impedance 1MOhm/47pF
Size 223*674*240 (H*W*D)
Unit Weight 14.0 Kg
Packing Weight 15 Kg
5
INPUT
POWER
AMP
CD IN
DRIVE
CLEAN
XTS REVERB
FOOTSWITCH
EQ SECTION
EQ SECTION
LOUDSPEAKERS
POWER
AMP IN
This loop is a series type
so all of your signal will go
through your FX unit.
PREAMP
OUT
FX
RETURN
FX
SEND