Laney – Laney CUB8 User Manual
Page 13
underside of the amplifier chassis. The preamp tube is retained by a wire clip, ease this away
from the tube and tube can then be gently pulled out. The output tube has a spring retainer
which must be pulled away before the tube will come out, see photo opposite. (Removal of
both tubes can be eased by applying a slight rocking motion as they are pulled, but ensure
that it is only slight, as the plastic location peg on the 6V6GT can easily be damaged).
Take care when pushing the new tubes into place, make sure the pins are
all aligned properly & that the rib on the base of the 6V6 tube is located
in the valve base correctly before fully fitting.
• Servicing: The user should not attempt to service these
products. Refer all servicing to qualified service personnel.
Laney
Page
13/ 16
CUB
8
Preamp Tube ECC83
Output Tube 6V6GT