Block diagram, Effects loop send, Footswitch – Laney GH50L User Manual

Page 9: Serial no, Displays the model and serial number of the unit

EFFECTS LOOP SEND:

Connect the input of your external effect to this socket. A ‘side chain’ effects loop allows you to

connect external effects such as tremolo’s, chorus and delays to your amplifier. Signal leaves the amplifier via the `Send’ socket and
comes back from the effects via the `Return` socket. Some Effects are better suited to being between the guitar and amplifer input -
these are foot pedal types / distortion / wah wah pedals etc. Rack mount effects will work better in the FX loop on the amplifer rear.
Stomp boxes are normally designed for small signals such as a guitar output whereas rack mount FX are designed for the higher signal
level obtained from an FX send.

FOOTSWITCH:

Connect a Laney FS1 footswitch here to allow remote switching of the front panel drive switch. The Drive

switch needs to be in the ON position for the footswitch to operate. The footswitch shorts the tip + ring together on a mono jack.

SERIAL NO:

Displays the model and serial number of the unit.

BLOCK DIAGRAM

HI INPUT

1*16 Ohm

FX RETURN

FX SEND

FOOTSWITCH

LO INPUT

PAD

DRIVE

GAIN

FX RETURN

8Ohms

4Ohms

BASS

MID

TREBLE

MASTER
VOLUME

BYPASS

INSERT
SIDE

CHAIN

SLAVE IN

SLAVE OUT

16Ohms

LOUDSPEAKERS

2*16 Ohm

1*8 Ohm

2*8 Ohm

1*4 Ohm

BIAS

5881/6L6

EL34

RESONANCE

PRESENCE

This manual is related to the following products:

GH100L