Eureka 6799 - Manual (Page 6)

HOW TO ASSEMBLE AND USE
Home Cleaning System Models 6877-6899 Series
Power-Touch ® Handle
Remote ON/OFF Selector
for bare floor or carpet
Carpet - push down on front
*Off - middle
Bare Floor - push down on back
*Power ON/OFF can be controlled on
some models from the Power-Touch
handle switch or canister ON/OFF
switch. Other models can only use the
canister switch.
Remote Speed Control (on some
models)
Regardless of the speed of the
canister motor, slide to reduce or
increase power as needed.
For Models
6820 - 6876
steps 1-4 and 7-9.
Detail B
7. Press cord into
channels.
8. Insert handle
end of hose
into assembled
wands.
9. Plug motorized
nozzle cord into
hose handle.
Vacuum Control (on
some models)
Cleaning suction is
reduced by pushing
lever to LOW position.
Place lever at High
position to increase
suction for carpet
cleaning. Available
on models without
Remote Speed
Control.
1. Snap interlocking wands together.
2. Push assembled wands into
motorized nozzle handle socket.
3. Place electric cord between cord
guide; turn to position (see Detail A).
4. Press cord into channel. If the
motorized nozzle cord plugs into
the end of the hose, refer to steps
7, 8 & 9 (see Detail B). Continue
below for the remote control
handle.
5. Push motorized nozzle plug into
retainer; secure cord in slot (see
Detail C).
6. Place Power-Touch hose
handle into wands until plug
connects and button locks.
Continue on next page to complete
assembly for both types of hose.
12
6
5
8
9
7
1
4
2
3
10
Select bare floor
or carpet cleaning.
Detail C
Detail A
Handle Release
Open slip
ring to
reduce
suction.
6