Epson X-PRF 1000 User Manual

Page 18

Text mode
Original mode

Setting Up th e PriorityFax

Rear

Front

hole

Place the output tray in front of you and insert each of the
two wire paper holders into the holes at the edge of the

output tray, as shown below.

To attach

the

output tray to

the

output tray base, locate the

holes on either side of the output tray base. Then

insert the

pegs on

either

side of the output tray into these holes, as

shown below.

Note

This tray can used in a horizontal position instead of
the vertical position shown on the next page. If you plan to
use the tray in the horizontal position, insert the pegs into
the rear slots instead of

the

front holes. Then push the

output tray as far back as it will go.

1-7