iSys iTerra Elite II Color LED Plotter - Manual (Page 13)

June 2011: Revision 001
13
STEP 10
On the support bracket loosen the adjustment setscrew lock nut.
Using a 1/8” allen key turn the height adjustment setscrew to set the stacker’s height to 1-13/16” (46mm) as
shown above. (Turn Clockwise lift and Counter Clockwise to lower)
Tighten the adjustment setscrew lock nut.
Move the ruler to the top left end of the Auto-Stacker’s funnel and repeat the height adjustment steps on the
left side.
Tighten the 2 left and 2 right mounting screws to secure the Auto-Stacker to the support brackets on the feeder.
Tighten the 4 support bracket screws.
Lock
Nut
Height
Adjustment
Setscrew
Mounting Screws