Irritrol Climate Logic - Manual (Page 8)

8
Receiver Module Installation
6. With the cover closed,
insert the Climate Logic
Setup Card into the
Receiver Module slot as
shown. Open the cover
to proceed.
Note: The Home screen
(right) will be displayed
only when a location has not been established, or has been
erased. Press the SET LOC key to display the Location screen.
7. Establish the site location as follows:
• Press MENU _ LOCATION _ ENTER to display the Location
screen.
Note: The Lat/Lon Location screen will be displayed by default.
To set the location using a 5-digit ZIP code, press the ZIP key.
• Press the or key to adjust the selected value. Press the
NExT key to select the next value in sequence.
• When the location information is displayed correctly, press
the SAVE key.
Note: The Receiver Module will begin transferring specific data
from Setup Card for the defined location. A confirmation screen
will indicate the completed transfer.
• Press the ExIT key (two times) to return to the Home screen.
8. Remove the Setup Card and stow inside the controller cabinet.
THIS SIDE UP THIS SIDE UP
CLIMATE LOGIC
MENU
1:15 a 11/16
69
F
30%
CLIMATE LOGIC
SETUP CARD CLIMATE LOGIC
SETUP CARD TM
CLIMATE LOGIC
MENU SET LOC
No Rain - Irrigation
MUST SET LOCATION
F 40%
– – –
CLIMATE LOGIC
SETUP CARD CLIMATE LOGIC
SETUP CARD
THIS SIDE UP
CLIMATE LOGIC CLIMATE LOGIC CLIMATE LOGIC
TM TM
CLIMATE LOGIC
MENU SET LOC
No Rain - Irrigation
MUST SET LOCATION
F
40%
– – –
Location
ZIP
00000
SAVE CANCEL LAT NEXT
Location
LAT
LONG
North America
-000.0000
00.0000
SAVE CANCEL ZIP NEXT
CL User Guide Final Edit.indd 8 2/11/11 5:19 PM