Electrolux EWW 1292 - Manual (Page 29)

ENGLISH
29
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning, make
a note of the model, serial number and purchase
date of your machine: the Service Centre will require
this information.
Mod. ..........
Prod. No. ...........
Ser. No. .........
M od. .......... Pr od . N o. ........... Ser . N o. .........
P0042 BD
P1035UK
Water is not
visible in the machine. The machine,
which is the result of modern technology, runs
in a very economical way with low water
consumption. Performance is
nevertheless excellent.
Problem Possible cause
• Spinning starts late or the
laundry is not spun enough:
• The machine will not dry or the
laundry is not dry enough
• The electronic unbalance detection device has cut
in because the laundry is not evenly distributed in
the drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several
times before the unbalance disappears and normal
spinning can resume. If, after few minutes, the
laundry is still not evenly distributed in the drum,
the machine will spin at a lower speed. If at the
end of the programme the laundry is not spun
enough, redistribute the load manually and select
the spin programme.
• The water tap is closed (E10).
• The drain filter is clogged (E20).
• The drying time or degree of dryness has not been
selected.
• An appropriate drying time or degree of dryness
has not been chosen.
• There is too much laundry inside the appliance.
The machine makes an unusual
noise. The machine is fitted with a commutator
motor which improves machine
performance.
P1034UK