Yaskawa VARISPEED-600 SERIES INVERTER - Manual (Page 15)

16
2. INSTALLATION
2.1 LOCATION
If the units are temporarily stored or machine stops for an extended length of time,
the following precautions should be taken. Store the units under the following con-
ditions.
: Free from rainfall and drops of water.
: Clean and dry.
: Free from corrosive gases and liquids.
: Free from dirt and dust.
: Ambient temperature: 14 to 104EF, −10 to 40EC.
: Humidity: 90% RH or less (no condensation)
: Free from vibration.
2.2 INSTALLATION
For full use of the braking resistor unit or braking unit functions, install the units
in a location to satisfy the following conditions:
Figs. 1 to 8 show the external dimensions and the spaces from the periphery.
: Provide the spaces shown in Figs. 1 to 8 between the units and the periph-
ery.
: Since the braking resistor unit generates heat, provide sufficient spaces
from devices which are weak against heat.
: Install the units at such locations that all requirements described in Par.
2.1 “LOCATION” are satisfied.
: Install the units in the directions shown in Figs. 1 to 8. There will be no
problem if they are installed vertically.