Yaskawa EUS61501X User Manual
Page 12

3 Safety Procedure
12
YASKAWA TOEP YEAOPT 06 YASKAWA AC Drive - G5HHP Power Supply Unit with Charge LED Safety Precautions
3.
After verifying the Power Supply Unit is safe, unplug and disconnect all wire connections and plugs from 4PCB
Tap Change Card as shown in
. Use an insulated #2 phillips screwdriver to remove wire connections on
terminal TB1.
Figure 5
Figure 5 Power Supply Unit Plug and Removal on 4PCB
4.
Remove the Power Supply Unit from the drive and install the replacement unit.
Ensure all plugs and wires are properly connected prior to applying power to the drive.
During removal, take precautions to ensure that nothing touches or comes into contact with the power supply bus
capacitor terminals that may still contain low voltages.
Side View
Unplug/disconnect
these plugs and wires
Do not
unplug
34CN