Yaskawa UUX000442 - Manual (Page 3)

Yaskawa Electric America, Inc – www.drives.com
IG.V7.51, Page 3 of 4
Date: 3/01/06, Rev: 06-03
Remote Operator (NEMA 1) Option Kit
UUX000443
13. Cut a hole in the remote operator-mounting panel as shown in Figure 4 for flush mounting.
Figure 4: Flush Mount Cutout (dimensions in Inches, not actual size)
14. For a flush mount, apply the gasket to the front side of the digital operator, and install the remote operator from the
rear side of panel. Insert the screws through the front side of the panel and then mount the washers and nuts to the
rear side of the panel. Four washers are not needed in this application. Tighten screws gradually from the front side
of the panel to prevent damaging the rubber gaskets. See Figure 5.
Figure 5: Flush Mount Installation