beautypg.com

Yaskawa CM090 User Manual

Modbus, Tcp/ip option kit cm090

background image

Yaskawa Electric America, Inc. –

www.yaskawa.com

IG.G5HHP.25 Page 1 of 9

Date: 10/12/09 Rev: 09-10

‰

This document applies to the Yaskawa G5HHP drive. Please disregard the installation guide packed in the option kit.

‰

Unpack the CM090 Modbus TCP/IP Option kit and verify that all components are present and undamaged.

‰

Connect power to the drive and verify that the drive functions correctly. This includes running the drive from the operator keypad. Refer to the appropriate drive technical
manual for information on connecting and operating the drive.

‰

Remove power from the drive and wait for the charge lamp to be completely extinguished. Wait at least five additional minutes for the drive to be completely discharged.
Measure the DC bus voltage and verify that it is at a safe level.

‰

Attach the CM090 Modbus TCP/IP Option card to the
master control board.
„

Attach the CM090 Modbus TCP/IP Option ground
wire to the ground terminal as shown. Make sure that
the terminal is connected to a reliable, noise free
ground.

„

Connect the CM090 Modbus TCP /IP Option card to
the 2CN connector on the master control board.

„

Secure the Cat-5 Ethernet cable to the support with a
tie wrap to provide strain relief for the connector.

„

Attach the Cat-5 Ethernet cable to the CM090 Modbus
TCP/IP Option
card as shown.

„

Fully engage the stand-offs in the mounting holes on
the card.

„

Route the Ethernet cable away from any power wires
within the cabinet. When outside of the cabinet, run the
Ethernet cable in its own conduit. However, it may be
run with low voltage signals such as feedback wiring.









‰

Apply power to the drive and verify that the drive functions correctly.
„

Verify that the MS/RUN and PWR LEDs on the CM090 Modbus TCP/IP Option are both GREEN. (Refer to the section on LEDs below.)

Modbus

®

TCP/IP Option Kit

CM090

CM090 Modbus TCP/IP Option Kit Parts List

Qty.

Modbus TCP/IP Option Card

1

Shielded RJ-45 M-F Cable

1

Ground Wire

1

4”x1” Insulated Tubing

1

Cable Ties

2

Installation Guide (IG.G5HHP.25)

1

Stand-offs

CM090 Modbus TCP/IP
Option Card Ground
Terminal

2CN Connector

Cat-5
Cable Support

CM090
Modbus TCP/IP
Option
Card

Attaching the CM090 Modbus TCP/IP Option on a G5HHP master control board.