Drive's i/o terminal – Yaskawa DI-003 User Manual

Page 2

Yaskawa Electric America, Inc. – www.drives.com

IG.G7.68, Page 2 of 3

Date: 10/27/05, Rev: 05-10

120VAC Interface Option Card

DI-003

TB3

Drive's I/O terminal

The P1 wire from both

cards will be inserted

and secured in SN

terminal and the

standard bare jumper

(not shown, concealed

between the two cards)

will be replaced with the

provided insulated one.

Both cards are shown,

installed at terminals.

S12

S10

S11

Figure 2. Installing both UTC000100 and UTC000120 on

the G7 to cover all 12 digital inputs, S1 thru S12.

10. Insert the option card’s P1 wire into the drive’s I/O terminal SN. This must be done before proceeding to step 11.
11. Insert the option card, with the input terminals facing up, into the drive’s I/O terminals S9 - S12 and tighten all 4 screws.
12. There are no adjustments to be made to this option card.
13. Reinstall and secure the drive’s front cover.
14. Place this instruction sheet with the drive’s technical manual.

Installing the DI-001 with DI-003 on the G7: To install both cards simultaneously, the following specific order must be followed
which combines the installation procedures outlined in the DI-001 and DI-003 installation guides.

1. Complete all main power circuit terminal connections as the installation of these boards may block wiring access.
2. Wire and install the UTC000120 option card for I/O terminals S1 - S8. Do not land the option card ground wire (P1) to the

drive’s I/O terminal SN.

3. Remove the standard bare jumper between the drive’s I/O terminals SC and SP and replace it with the insulated jumper

included in the DI-003 kit. The provided insulated jumper will prevent any electrical and mechanical disturbances to the option
card installation.

4. Complete all wiring to the I/O terminal’s second row, as the installation of the UTC000100 card will block access to these

terminals.

5. Insert both the UTC000100 and UTC000120 cards’ P1 wires into terminal SN of the drive.
6. Wire and install the UTC000100 option card for I/O terminals S9 - S12.