Excalibur electronic EZ Crank Radio Extreme H632S-WC - Manual (Page 3)

Operating your Flashlight
Using LED Selector
• Click the switch up once
to use a single LED. This
is useful as a spotlight,
when you don’t need to
use the maximum
amount of light.
• Click the LED selector
switch one more time to
activate all 3 LED lights,
giving you the maximum
amount of light.
To charge using an AC
outlet
1. Turn the pivoting handle
90 degrees in order to
expose the polarized
plug.
2. Rotate the plug 90
degrees and insert
directly into an
standard 120V AC outlet.
3. Charge the unit for
24 hours.
4. Once fully charged, the
fl ashlight will last
approximately 80
minutes using the single
LED light or 40 minutes
using the triple LED
lights.
5. When left plugged into
the AC outlet with the
ON/OFF switch set to
the ON position, the
fl ashlight will turn on
automatically if the
power goes out.
6. The red nightlight will
automatically turn on
when the unit is plugged
in.
To charge using the EZ
Crank handle
1. Lift the EZ Crank handle
and turn clockwise.
2. Charge your fl ashlight
by turning the EZ Crank
at a speed of 120
revolutions per minute.
3. One minute of turning
will provide roughly
80 minutes using a
single LED light or 40
minutes using the triple
LED lights.
Replacing the Ni-MH
Rechargeable Battery
1. Remove the battery
cover, using a fl at-head
screwdriver.
2. Disconnect the battery
and replace with a
new Ni-MH 3.6V 80mAh
battery.
3. Replace the battery
cover.
Special Care and Handling
1. Avoid excessive
humidity, moisture, and
extreme temperatures.
For best results, store
the unit between the
temperatures of 14° F
and 122° F (-10°C and
50° C).
2. Do not immerse the unit
in water.
3. Clean using only a damp
cloth. Do not use any
chemicals or solvents.
4. To maintain a bright,
intense beam of light,
use a damp cloth with
mild soap and water to
clean the transparent
bulb cover.