Emerson Radio MS3110 - Manual (Page 23)

22
Notes:
• After pressing the PROGRAM or MEMORY button to begin setting the clock,
you must press the SKIP – ( ) / SKIP + ( ) or TUNING / TUNING
buttons to adjust the display within 10 seconds, otherwise the digits stop flashing
and the time cannot be adjusted. If this occurs, press the PROGRAM or
MEMORY button again and then press the SKIP – ( ) / SKIP + ( ) or TUNING
/ TUNING buttons within 10 seconds to adjust the display.
• The display will always show the time when the system is in the Standby (Off) or
AUX mode.
• To see the time while the system is in the Tuner or CD mode, press the MODE
button on the front panel (there is no MODE button on the remote control).
• The display will show the correct time for approximately 10 seconds and then
return to the Tuner or CD display mode.
MS3110_112106.p65 22/11/2006, 11:48 22