Echo CS-8000 TYPE1-E - Manual (Page 17)

15 CS-8000 TYPE1-E
WHEN THE ENGINE IS HARD TO
START
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
s
chain brake before starting.
s
grasping throttle trigger and push in throttle
latch.
s
starter handle.
s
release throttle trigger for disengaging throttle
latch and returning engine to idle, and pull front
hand guard towards the operator immediately.
(Chain brake unlocked position)
CAUTION
1. When using throttle latch for starting, keep
the brake in lock position.
2. After starting the engine, immediately
squeeze and release throttle trigger for
disengaging throttle latch and returning
engine to idle, and pull front hand guard
towards the operator immediately. (Chain
brake unlocked position)
3. Do not increase engine speed while chain
brake is locked.
4. Use the chain brake only in starting or in
emergencies.
CAUTION
The chain will attempt to rotate when engine
is started with throttle latch engaged. After
engine starts, release throttle trigger to idle
engine, otherwise brake damage may occur.
Never use throttle latch for cutting. Use it
only when starting the engine.
WHEN THE ENGINE IS WARM
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
s
chain brake before starting.
s
starter handle.
s
push it back on first firing sound.
s
towards the operator immediately.
(Chain brake unlocked position)
Throttle trigger
Throttle trigger
lockout
Unlock chain brake
Choke control knob
Choke open
Unlock chain brake
Starter handle
Start / Run
Ignition switch
Chain brake
Throttle latch
Push