Polaris 2014 ATV Sportsman 550 EPS - Manual (Page 45)

43
FEATURES AND CONTROLS
Instrument Cluster
Multi-Function Display (MFD) Gauge (EPS Models)
4. Fuel Gauge - The segments of the fuel gauge show the level of fuel
in the fuel tank. When the last segment clears, a low fuel warning is
activated. All segments including the fuel icon will flash. Refuel
immediately.
Tip: If the fuel icon fails to display, an open or short circuit has occurred in the
fuel sensor circuit. See your dealer.
5. High Beam Indicator - This indicator illuminates when the lights
are set to high beam.
6. Engine Overheat Warning - This icon flashes to indicate an over-
heated engine. If the icon stops flashing but remains illuminated,
the overheating condition remains, and the system will automati-
cally reduce engine power.
7. Clock Display - The clock displays time in a 12-hour or 24-hour
format. If the engine is turned off, press the MODE button. The
time will display for 5-10 seconds. See page 46 for resetting instruc-
tions.
8. Service Reminder Display - A flashing wrench symbol alerts the
operator that the preset service interval has been reached. The vehi-
cle should be brought to your dealer for scheduled maintenance. See
page 46 for resetting instructions.
9. Under / Over Voltage - This warning usually indicates that the
ATV is operating at an RPM too low to keep the battery charged. It
may also occur when the engine is at idle and high electrical load
(lights, cooling fan, accessories) is applied. Drive at a higher RPM
or recharge the battery to clear the warning.
10. Check Engine Warning - This icon displays if an EFI-related fault
occurs. Do not operate the ATV if this warning appears. Serious
engine damage could result. See your dealer.
11. 4X4 Display - This icon displays when the 4X4 system is engaged
(switch is on either ADC 4X4 or 4X4).
12. Neutral Indicator - This indicator illuminates, in addition to dis-
playing in the gear indicator display, when the transmission is in
neutral.
13. EPS Warning Indicator - If this indicator light remains on after
starting the engine, the EPS system is inoperative. See your autho-
rized Polaris dealer for service.