Polaris 1999 ATV Sportsman 335 - Manual (Page 4)

4
Optional Suspension Springs
SOFT FIRM
Sportsman 335 4x4 - Rear Compression Spring 7041517-067
OPTION
80 lb/in
7041546-067
STANDARD
100 lb/in
7041519-067
OPTION
140 lb/in
Sportsman 335 4x4 - Front Strut Spring 7041238-067
OPTION
61 lb/in
7041375-067
STANDARD
64/113 lb/in
7041450-067
OPTION
101 lb/in
Air Filter Service
1. Remove seat.
2. Remove wingnuts securing the airbox lid and remove lid.
3. Pull foam breather filter out.
4. Loosen clamp and remove filter.
5. Remove foam pre-cleaner from main filter.
6. Wash the pre-filter in soapy water and dry it.
7. Install dry pre-filter over new main filter and reinstall.
8. Push foam breather filter straight down into airbox until flush with up-
per edge of box. Make certain foam is flush with front edge of airbox
so air cannot enter engine breather fitting hole without first passing
through the foam.
Breather Filter and Hose
1. Remove the clamps and pull the filter out of the hoses. NOTE: It
will not be necessary to remove the lower hose from the engine.
2. Inspect filter for debris. Blow through gently in direction of arrow on
filter to check for clogging. Replace as needed.
3. Check hoses for cracks, deterioration, abrasion, or leaks. Replace
as needed.
4. Reinstall filter and clamps with arrow pointing toward engine.
NOTE: The breather filter is intended to be used with airbox
pre-filter in place. Without the pre-filter, the breather filter can clog
quickly. Never operate the ATV without the pre-filter.
PN 9914987 Rev 02 12/98
Printed in U.S.A.
Main Filter
Foam
Pre--cleaner
Breather
Filter