Grass Valley TTN-RECL8 - Manual (Page 8)

RECL8 Rev. 2
2
2 Power connection
Do not connect mains to the desktop power supply before connecting the power supply to the
router.
Connect the DB9 female connector from the desktop power supply to the main unit. Tighten the screws to
assure a proper contact. To connect mains to the desktop power supply you need a mains cord with IEC
320 connector.
Each RECL8 unit is normally delivered with the desktop power model AC ±5V / 30W. Upon customer
request, RECL8 can also be delivered with DC ±5V / 30W, which may be fed by a 36 – 72 VDC mains
power source. A Frame mounted power supply solution is also available.
Please refer to the latest Triton Product Catalogue for power supply types, or call Thomson Grass Valley
for this information.
If any third party power supply is used each RECL8 requires +5V DC with a minimum current of 1.0A.
The following pin-out is used on the DB9 male power connector:
Pin
1 0V
Pin 2 +5V
Please see marking on the screw terminal of your unit.
Please Note! The unit can either be used with +5V power connected via DS9 connector or battery
power connected via screw terminal.
Please connect battery power via the screw terminal on the right hand side of the unit. (back-plane view)
Before connecting battery power please check that the correct voltage is marked below the screw
terminal.