Grass Valley PFR 500/E Dec 12 2002 - Manual (Page 26)

Chapter 2 PFR500/E Installation Information
26 PFR 500/E Instruction Manual 20 September 2002
Chassis address setting requirement
Each PFR500/E storage chassis has a chassis address switch that must be set to a unique
chassis address. Valid chassis addresses are 0-9 with 0 being reserved for the PFR500
RAID Chassis. All chassis are shipped with the chassis address set to 0.
The chassis address switch is located inside the chassis on the midplane board. The
following figures show how to gain access to the switch by removing the board canisters.
CAUTION: Refer to the PVS Series Installation Guide you received with your Profile XP
storage system or the Media Area Network Instruction Manual for step-by-step
instructions for setting the chassis address.
The midplane is at the back of the slot that held the LBB canisters. On the midplane is a
small, white rotary switch.
.
3001
LBB A goes
in the bottom slot
LBB B goes
in the top slot
2796