Echo GT-201 - Manual (Page 25)

G
RASS
T
RIMMER
O
PERATOR
'
S
M
ANUAL
25
4. Hold spool with words "WIND LINE" and tap knob towards you.
Place index finger between the two lines and wind line clockwise
tightly and evenly.
5. Place ends of line in the two notches (B) molded in the spool with
12.5 cm to 15.2 cm (5 in. to 6 in.) protruding.
6. Place spool in housing against spring (C); thread line ends through
housing eyelets (D)
7. Align cover arrow with housing tab; push down on cover and twist
clockwise until cover locks in place.
8. Pull both lines out and trim to cut-off knife length.
Before installing, test head. Push center button while pulling on
both lines. Trimmer line should advance approximately 1 (one) inch.
D
D
C