Grass Valley AMX-1101 - Manual (Page 6)

GUIDE TO INSTALLATION AND OPERATION
2 | AMX-1101
2 Installation
2.1 Preparation
The following items are required for the installation of your AMX-1101 in a Densité-series frame:
• AMX-1101-DRP Rear Panel (for Densité 2 frames) or AMX-1101-DRP-3RU (for Densité 3 frames)
• AMX-1121 AES Embedder (2RU or 3RU, per frame type)
• ADC-1722 Dual Analog Audio-to-AES Converter (2RU or 3RU, per frame type)
Note that the AMX-1101-DRP rear panel may be ordered separately, if the user already has the two associated cards.
2.2 Installation in the Densité frame
The rear connector panel (AMX-1101-DRP or AMX-1101-DRP-3RU) must be mounted in the Densité frame before
installing the cards. It is not necessary to switch off the frame’s power when installing or removing the rear panel or
cards. See the Densité frame manual for detailed instructions for installing cards and their associated rear panels.
1. Install the rear panel so that it covers two adjacent free slots in the Densité frame. Install the rear panel with the
cards out of the frame.
2. Install the AMX-1121 in the leftmost of the two slots occupied by the AMX-1101-DRP (as seen from the front of
the frame)
3. Install the ADC-1722 in the rightmost of the two slots occupied by the AMX-1101-DRP (as seen from the front of
the frame.
If a card is placed in the wrong slot, its front panel LED will flash red. Move the card to other slot for correct operation.
No damage will result to the card should this occur.