Grass Valley 7600REF Installation - Manual (Page 12)

12 7600REF — Installation and Safety Manual
Frame Installation
Frame Installation
Follow the instructions below to unpack and install the 7600REF frame. For
more detailed instructions and cabling the rear of the frame, refer to the
7600REF Instruction Manual.
Unpacking
Carefully unpack the unit from its packing box and check for signs of
damage. Check the contents of the box against the packing list and your
original order to ensure that you have received the correct parts.
In the event the unit has been damaged or does not match your order,
contact the Thomson Grass Valley Sales office listed on
Contacting Grass
Valley on page 2 .
Rack Mounting
The 1 RU rack frame has integral rack mounting ears on the frame front
cover for direct mounting into a standard 19 inch rack. Carefully place the
unit in your rack and firmly attach it to the rack using four standard rack
screws (not provided).
CAUTION This unit has air intakes on one side of the unit and fan-assisted exhaust vents
on the other side. Ensure that these vents have an unobstructed air flow, to
prevent the unit from overheating. Pay particular attention to ensure that any
rack wiring or cable trays do not obstruct the vents. 60 mm (2.36 in.) of clear
space should be allowed between the vents and any potential obstruction.
Module Installation
No installation of any modules should be necessary. All modules will come
installed in the frame from the factory. The presence of modules depends
on the 7600REF model you have ordered. Software options for the frame
type you have ordered will already be enabled when the frame is received.