Exmark Lazer Z CT - Manual (Page 38)

33
FIGURE 8
4.2.7 Electric Clutch Adjustment:
No adjustment necessary.
4.2.8 Reverse Indicator Adjustment:
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Unhook seat latch and tilt seat forward.
c) Begin with either the left or right motion control lever. Move lever to the
neutral position and pull lever back until the clevis pin (on arm below pivot
shaft) contacts the end of the slot (just beginning to put pressure on spring),
See Figure 9.
d) Check where lever is relative to notch in console (should be centered
allowing lever to pivot outward to the neutral lock position).
e) If adjustment is needed, loosen the nut against the yoke and while applying
slight rearward pressure on the motion control lever, turn the head of the
adjustment bolt in the appropriate direction until lever is centered (keeping
rearward pressure on the lever will keep the pin at the end of the slot and
allow the adjustment bolt to move the lever to the appropriate position).
Tighten lock nut.
f) Repeat on opposite side of unit.
4.2.9 Motion control linkage adjustment
WARNING
POTENTIAL HAZARD
♦ Engine must be running and drive wheels
must be turning so motion control
adjustment can be performed.
WHAT CAN HAPPEN
♦ Contact with moving parts or hot surfaces
may cause personal injury.
HOW TO AVOID THE HAZARD
♦ Keep fingers, hands, and clothing clear of
rotating components and hot surfaces.