Eneo VKC-1332/3.6SMD - Manual (Page 4)

1.To screw board camera to installed object.
2.Supply DC 12V to power lines and connect
video line to video output lines.
* See sketch chart 1 power line red +12V,
black ground. (with protection function of
DC +/- polarity reverse) 2 video output
white + , black -
* Maybe burn out camera by mis-connection
to excessive AC voltage.
3.Adjust focus length of lens to get clearer image.
(To select suitable board lens depending on
installed environment to get reasonable view
angle).
FUNCTION DESCRIPTION
VIDEO
360 deg
Screw
hole
COLOR
DC 12V IN
INSTALLATION
NOTES :
1. Never supply AC or more than DC 15V to
power line.
2. Supply stable power , otherwise easily
produce noise.
3. Using 75 ohm input impedance for display
unit.
4. Handle with care to wiring.
5. Don’t repeat several times to plug-in and
plug-out connector on camera board.
Screw
hole
Lens
B/W
Lens
1.Supply DC 12V to 1 power line and
composite video signal from 2 video output.
2.Current 120 mA.