Eneo HDB-1080Z03IR D - Manual (Page 5)

5
EN
Part names
Power cable
OSD setup control cover
Dual window
Front case Rear case
Bracket
Easy bracket
Installation instructions
CAUTION: The camera’s base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed. i The easy bracket can not be installed on the ceiling.
2. Place the easy bracket on pre-drilled position and fix it through using mounting
screws (4x35mm). Skip this step when an easy bracket is not installed.
3. Route the power cable to the connecting place. Hook up the camera bracket with
the easy bracket as illustrated below.
4. Fix the camera bracket through using assembly screws (4x12mm).
5. Set the camera’s viewing angle.
1
2
4
3
Assembly Screw: 4x12mm
Torque Wrench
Mounting Screw: 4x35mm
Cable exit