Eneo HDD-2080Z03IR D - Manual (Page 19)

19
EN
Set the video format according to system, EX-SDI or HD-SDI
To select the camera’s output video format (EX-SDI or HD-SDI), use the Video format
Switch on the side of the camera (see also “Using OSD controller” for location of the
switch). Only one format can be used at a time. The Video sub-out Connector signal is not
affected by the switch setting.
OSD menu startup
Press ‘ ●’ (OSD menu Joy stick key) down for about 2 seconds to access the setup menu
mode.
Lens Initializing is strongly recommended at the first stage of setup menu control. ZOOM/
FOCUS > LENS INIT > Press the joystick ‘ ☟’ straight down for about 2 seconds.
1M~120M via RG59u or 5C2V cable
Camera (HD-SDI)
DVR (HD-SDI)
Camera (HD-SDI)
1M~120M via
RG59u or 5C2V
cable
350M+ via RG59u or
5C2V cable
HDA-3000E
(EX-SDI)
HDA-3000E
(EX-SDI)
1M~120M via
RG59u or 5C2V
cable
DVR (HD-SDI)
Camera (EX-SDI)
350M+ via RG59u or 5C2V cable
HDA-3000E
(EX-SDI)
1M~120M via
RG59u or 5C2V
cable
DVR (HD-SDI)
350M+ via RG59u or 5C2V cable
Camera (EX-SDI) DVR (EX-SDI)
Camera (HD-SDI)
DVR (HD-SDI)
1M~120M via
RG59u or 5C2V
cable
1M~120M via RG59u or
5C2V cable
HDA-3000E
(EX-SDI)
HDA-3000E
(EX-SDI)
1M~120M via
RG59u or 5C2V
cable